This translation service is provided by another company, not by Aldon Corporation. Aldon Corporation is not responsible or liable for translation errors. Some flag selections may not be active. The translations that are working currently, in the left to right order of the flags are: xxxxxxxx - German - xxxxxxx - xxxxxxx French - Italian - Portugese - Spanish .

CAUTION: Please read this before reading the label:

We are concerned about the quality of this translation because it is done by computer software. Please understand that some things might sound foolish, insulting, or possibly not make sense. This is because Aldon has no ability to insure the accuracy or appropriateness of the translation. Therefore, we offer this translation for any value that it might give you, but please excuse the errors that might be contained herein. Please see the English language label on the Aldon web page and ask someone to translate it for you in case of any miscommunication. Aldon Corporation takes no responsibility or liability for any miscommunications.

To print this page - type "Control Key" and "P"

ALDON FINE STONE RESTORATION 08/01

For the restoration of limestone and marble finishes, except “high polish”. Spills from acidic drinks will create a permanent etch mark on limestone and marble that cannot be cleaned, but can be polished out.

You will be using this product to duplicate the process the factory uses to create the original finish on the stone, only on a smaller scale and by hand.

For information and assistance visit aldonchem.com.

You will want to use the LEAST aggressive polishing technique first, and only use the more aggressive technique if the etching is deep and requires it.

Do not allow contact with enameled, chromed, metal plated, aluminum, or other non-acid resistant surfaces. Clean equipment with clean water. Always patch test a small area first. Open cap slowly to vent!

Wear rubber gloves and all else necessary for protection of breathing, eyes, and skin while handling acid based products.

Least aggressive technique for light etches: Squeeze enough liquid into a piece of “0000” steel wool (available from hardware and paint stores) to saturate and rub the etched spot in a circular motion. (Note: The liquid will eventually rust the steel wool, so do not reuse the steel wool if rusting has occurred.) Continue until etch is no longer visible. Observe at an angle to a light source for the best viewing. Rinse thoroughly - avoid food contact.

Most aggressive technique for deep etches: Squeeze liquid into a “fine textured sponge sanding block” (available from paint stores) and rub the etched area in a circular motion. The sponge sanding block will hold the liquid and provide a “rougher” surface than the steel wool. Continue until the etch depth blends into the surrounding area and is only visible as a “rougher, duller” area on the stone surface. Then switch to the least aggressive technique above to achieve a finer finish.

Polished Marble: This technique works on highly polished marble also, but the area will be dulled down to the equivalent of a “honed” finish. The “mirror like” finish of this material might also require additional treatment beyond the above. See our web site for the latest available products and techniques.

FIRST AID: Do not induce vomiting. Immediately drink large quantities of water. Call a physician or Poison Control Center. IF INHALED - If odor is strong or you notice dizziness, headache or eyewatering - STOP-leave area immediately. IF EYE/MUCOUS MEMBRANE CONTACT OR SKIN IRRITATION: Flush with water for at least 15 minutes. Remove contaminated clothing & footwear. If irritation persists, get medical attention. IN ALL CASES-Immediately Contact a physician & Poison Control Center! Emergency = 800-535-5053 or 352-323-3500.

WARNING:CORROSIVE MATERIAL. Contains oxalic acid. Avoid if allergic. Harmful or fatal if swallowed. Vapor harmful. Avoid prolonged contact with skin. Use only in a well ventilated area. Keep away from heat or open flame as could produce toxic gases. Do not transfer contents to other unlabeled containers. Close container after use. Non-photochemically reactive. This product contains no reported carcinogens or suspected carcinogens. We believe that there is no significant risk in the normal use of the product. Intentional misuse by deliberately concentrating and inhaling contents may be harmful or fatal. Keep out of reach of children! NOTE: Patch testing is always advisable to insure the results will be as expected. Each application has a different set of variables and because of possible miscommunication or misunderstanding of the conditions, final approval, prior to use, must be the responsibility of the user, regardless of recommendations by the manufacturer or seller. The information contained herein is to the best of our knowledge and belief accurate, however, due to the fact ALDON has no control over proper surface preparation or application methods, no guarantee as to results is offered, expressed or implied. ALDON products are inspected before shipment and conform to ALDON'S usual standards of quality for such goods at the time of shipment to ALDON'S purchaser. All other warranties whether expressed or implied, including any warranties of merchantability and fitness for purpose, but without limitation thereto, are expressly excluded. ALDON shall not be liable for consequential or special damages, nor for any damages in excess of purchase.

 ALDON CORP.- Reno, NV. 89504
TM: Trademarks of Aldon Corporation © 2001, Aldon Corporation